Check out this impressive GT350 build by site member LAPTIMZ inspired by and incorporating parts from the Mustang FP350s, a turn-key race car designed by Ford.

The Shelby FP350S was developed to compete in the Trans Am and SCCA racing classes, and LAPTIMZ’s GT350 certainly looks like it’s straight off the race track. Here is the full list of extensive mods currently:

GT350 MODS (see full build thread)

FP springs
APR GT250 wing
Custom Resonator Delete
Custom Drive Control Mount
FP350s trunk support rods Tig welded
Capaldi Racing Splitter
Capaldi Racing HD pencil rods
Quick latch 1” bumper clips
MM Camber Plates
Caliperflexion bolts
FP Front Tow Hook
FP Rear Tow Hook
R Splitter
ST43 pads
JLT Catch Can
Sparco pro ADV Halo seat
Planted seat Brackets
Universal Seat Sliders
Cooltech belt clips
Watson Racing Roll bar
Schrothe 6 pt Harness
Watson Racing Rear seat delete
SRP Pedals
Wide Angle Rear View Mirror
Gorilla Lugs
Gas pedal spacers
31mm Wheel spacers
MSI Extended R Spec Studs
Open End Lug Nuts
BMR Camber Bolts
AWE Exhaust valve remote
Bemaro Red Shelby overlay
ZL1 addons splitter guards
AJ Hartman Splitter Biscuits
Ford Performance Air Intake
Gold reflective Heat Shielding
Ford Performance Windshield Banner
Laguna Pipes (High Temp heat wrap)
Black Vynil Roof Wrap
LaminX Yellow Headlight film
Steeda clutch Spring
FTB Rear camber arms
Carbing gold shift knob
Billet 3” shifter extension
MGW Shifter
FP Front and Rear Sway bars
FTB Front sway bar end link
UPR Ford Billet Oil Drain Plug Magnet
J&M Frnt Cntrol Arm Spherical Caster Bearing
19×11 et50 Signature Forged SV702
FP Tie Downs
Redline Hood Struts
Carter Customs FP350s Hood Vent
Singular Motorsports GT250 End Plates
NRG 2.5 Quick Release
NRG Short Hub Adaptor
SABELT 733 Ferrari Challenge Steering wheel
Aerocatch hood pins
AiM SOLO2 DL
AiM Smartycam
ASR Harness Bar Reels

Check out the full set of photos and follow the build here.

Be Sociable, Share!

Leave a Reply

Follow

Get every new post on this blog delivered to your Inbox.

Join other followers: